Amplificador Marinizado 4 Canais MTX WET75.4

MTX gets WET

MTX brings their years of land-based experience to the water with their WET Series marine components. Based on their Thunder Series amps, the WET75.4 4-channel amplifier is designed to power your speakers under seriously adverse conditions. Its weather-resistant features include a conformal coated circuit board, stainless steel hardware, rubber gaskets around the RCA connectors, and plastic control covers to keep moisture from getting to the amplifier. The 75.4 also features MTX's surface mount technology, which attaches critical components directly to the circuit board to minimize the effect of vibration.

Power and control

Behind the weatherproofing and the construction, you'll find a Class A/B 4-channel amplifier capable of delivering 75 watts per channel at 4 ohms, or 100 watts at 2 ohms. Variable high-pass filters on the front and rear outputs, along with a variable low-pass filter on the rear outputs, allow you to fine-tune the sound environment. And MTX made this amp to fit the tight spaces in a boat, with a small footprint that allows it to go almost anywhere and an extruded heat sink that'll keep things cool. It's ready to make waves. Are you?

Features & specs

Performance

RMS Power Output (Watts x Channels) 75 x 4

Frequency Response at Rated RMS Power ---

THD at Rated RMS Power 0.05%

Signal to Noise Ratio 78 dB

Input Voltage 14.4v

Peak Power Output (Watts x Channels) 200 x 4

Power at 2 Ohms (Watts x Channels) 100 x 4

Bridged Power (Watts x Channels) 200 x 2

Minimum Impedance Bridged 4

Minimum Impedance Unbridged 2

Features

Amplifier Class AB

Low-Pass Crossover Frequency 50-750 Hz

Low-Pass Slope (dB/octave) 12 dB/octave

High-Pass Crossover Frequency 10-750 Hz

High-Pass Slope (dB/octave) 12 dB/octave

Bass Boost No

Bass Boost Frequency N/A

Fan Cooled No

Fuse Rating 60

Speaker Level Inputs No

Preamp Outputs No

Height (inches) 2-1/4

Width (inches) 12-5/8

Depth (inches) 6-3/8